Why do stone router add water tank

 

First, the stone router spindle needs to be water-cooled during processing, and the other is that the engraving tool also needs to be watered during processing. The standard stone engraving machines are all double-cooled. On the one hand, due to the hard material of the stone, the cutter head needs to be water-cooled when working. This is also the role of adding the water tank.
 
The water can prevent the spindle temperature from being too high and play a certain protective role on the spindle. However, if the opearater does not pay attention or does not work following up the training steps, the phenomenon of no water and dry burning will occur, which will cause serious damage to the machine itself. Therefore, at this time, the operator is required to pay attention to this when operating. The training personnel should also make this point clear to the operators.
 
After understanding the introduction of the above two points, I believe that everyone has a certain understanding of why the stone router need to add the water tank.