1. Acrylic cutting processing, single-edged spiral milling tool is recommended. It is characterized by smokeless and odorless processing, fast speed, high efficiency, non-sticky chips, and truly environmentally friendly. Its special manufacturing process ensures that acrylic does not burst. , Very fine knife pattern (even no knife pattern), smooth and smooth surface. The machined surface needs to achieve a frosted effect, and a double-edged three-edged spiral milling cutter is recommended.

2. For density board cutting processing (for advertising mold opening), double-edged large chip-removing spiral milling tool is recommended. It has two high-capacity chip-removing grooves and a double-edged design, which not only has a good chip removal function, but also achieves Good tool balance, no blackening, no smoke, and long service life when processing medium and high-density boards.

3. For aluminum plate cutting, it is recommended to use a single-edged special aluminum milling cutter. No sticking to the knife during processing, fast speed and high efficiency.

4. It is recommended to use single-edged, double-edged up and down cutters for cutting without burrs on the upper and lower sides.

5. For metal engraving, single-edged, double-edged straight groove flat-bottomed sharp tools is recommended.

6.3D carving tools, high concentricity, sharp cutting edge, can be used for precision 3D carving processing.

7. It is recommended to use prismatic tool for high-density boards and solid wood.

8. For multi-layer board and splint processing, double-edged straight groove milling cutter is recommended.

9. For precision small relief processing, a round bottom cutter is recommended.

10. For the processing of large deep reliefs of cork, MDF, virgin wood, PVC, and acrylic for stone engraving machine, single-edged spiral ball-end milling cutter is recommended.

11. For metal mold processing milling cutters, tungsten steel milling cutters are recommended, and the surface is plated with purple black and hardened titanium.

13. It is recommended to use a diamond carving tool for acrylic mirror engraving.

14. It is recommended to use multi-stripe milling cutters for rough processing of particle boards on stone engraving machines.